1) Fixture body die-casting aluminum alloy.

2) Electrostatic spray coatingsurface treatment .

3) Fixture body and light source box are designed separately so as to reduce ceiling bearing, decrease light source box temperature and increase device reliability. Since it uses spring-plate fastener fitting mode, it is easy for mounting and suitable for ceilings of different thicknesses.

4) Reflector is made of 0.6mm highly purified aluminum, anodized or sand sprayed treatment, thus forming various lights.

5) Lamp holder G12 or RX7s.

6) Single-end metal halide light source or double-end metal halide light source.

7) Light source may select electronic ballast and inductance ballast. As compared with inductance ballast, electronic ballast can save energy by 30%.

8) Introduction of engineering PVC surface frame and 5mm hardened glass can ensure that surface frame will not general dust.

9) Internal connecting wire 1 mm2PVC.